My T post puller

[SSdoxie]

Here is a little gadet that saves some time and effort pulling T posts. Took me about 15 minutes this afternoon making it from some scrap angle iron laying around.
In the photos I was pulling off the Quick Hitch on 3 pt. Just back up close to post, drop the triangle over the post, lower 3 pt, then pull, up comes the post.

The triangle measure 5 1/2" from top joint to the cross angle. This one is 2 1/4" wide at the bottom. I think 1 3/4 or 1 7/8" would work better since this on did slide off to an angle a slipped on 1 psot out of the 8 I pulled, a little narrower will keep it from twisting off center.

 

[SandburRanch]

Here is a little gadet that saves some time and effort pulling T posts. Took me about 15 minutes this afternoon making it from some scrap angle iron laying around.
In the photos I was pulling off the Quick Hitch on 3 pt. Just back up close to post, drop the triangle over the post, lower 3 pt, then pull, up comes the post.

The triangle measure 5 1/2" from top joint to the cross angle. This one is 2 1/4" wide at the bottom. I think 1 3/4 or 1 7/8" would work better since this on did slide off to an angle a slipped on 1 psot out of the 8 I pulled, a little narrower will keep it from twisting off center.

Good job on the puller. It looks as if it will slide down by gravity for a second bite if needed.

 

[jimmyj]

Looks great. If the t post has no bumps, you can put a bolt through. Handy.

 

[weldingisfun]

Thanks, SSdoxie, I will add that one to the list of ideas stolen from someone else.:laughing: Great job!:thumbsup:

 

[yomax4]

Making one on friday..Thanks. :thumbsup:

 

[moored4]

Nice! :thumbsup:

 

[Sackett2]

love the simple design; will make one soon

 

[richtape]

Thanks for the idea. I made 2 last week. I'm retired & pittle around in my shop most of the time. I like building stuff like this & giving it to people just to watch their reactions. Great little tool thar really works.
Any more ideas?

 

[jobguy]

I like the puller a lot. Good job.:thumbsup:

 

[carlav1410]

nice Job,

Good little tool to have around and make a job fast and easy.
Or its a chain and a helper to do the same job in the same time.

Nice Job