MX-5 Gear Box

   / MX-5 Gear Box #1  

Red Horse

Veteran Member
Joined
Dec 12, 2010
Messages
1,156
Location
Bolton, MA
Tractor
Deere 655ZTrak, Deere 4720 Cab, 400 X LT 155
I bought a used MX-5 mower and do not have a manual. Can anyone tell me what the proper fill level is in the gear box. When I pull the filler plug there is about 1/2" showing on the stick-as the stick is about 2 or 3" long, that leaves a lot of potential fill capacity. Also 80/90 gear lube???
Thx
 
   / MX-5 Gear Box #2  
Normal fill is center line of the input shaft. 80/90wt is fine.
 
   / MX-5 Gear Box #3  
There are two "lines" at the bottom of the flill plugs "stick" that sticks down into the gearbox. You fill till the oil is between those to line with the fillplug/dipstick screwed in fully. Reading from my Deere manual for my MX 6 it states; " Install dipstick/vent and screw in fully, then remove,oil should be between lines. Add oil as nessesary."

Don't over fill as this won't leave enough space for expansion of the oil as it heats up and you'll have a "gusher" on your tractor. Good luck with the MX5.
 
   / MX-5 Gear Box
  • Thread Starter
#4  
Thx guys-kind of assumed the double line was a "low/Max" point but you now what they say about "ASSuming"!
 
   / MX-5 Gear Box
  • Thread Starter
#6  
Thx John
 

Tractor & Equipment Auctions

2004 Jeep Grand Cherokee SUV (A50324)
2004 Jeep Grand...
2012 Hino 262 Rollback Tow Truck (A50323)
2012 Hino 262...
2013 Ford E-350 Enclosed Service Van (A50323)
2013 Ford E-350...
2018 Gatormade 20+5 Gooseneck Trailer (A52748)
2018 Gatormade...
2013 Toyota Prius Hatchback (A50324)
2013 Toyota Prius...
2021 KYRV (A50324)
2021 KYRV (A50324)
 
Top