MT225E Random Cotter Pin
- Thread starter Waffles
- Start date
- Views: 842
ruffdog
Super Star Member
- Joined
- Dec 31, 2011
- Messages
- 12,492
- Location
- cowville, banana republic
- Tractor
- Bobcat Toolcat 5610G, Deere X744, Cub Cadet IH 982
I'm wondering if that is a drain hole for the clutch area? If oil starts to drip out, a seal is leaking. The cotter pin keeps it from plugging as it moves around.
Tinhack
Elite Member
- Joined
- Jul 3, 2020
- Messages
- 3,511
- Location
- Lytle, TX
- Tractor
- Ford 3910, John Deere 420C, Kubota G32XKS, IH 2606, Bad Boy Maverick-60"
Agree. I've seen this technique used on many machines to keep a weep hole clear. Works good on all but the dirtiest conditions--Like the bottom of a tractor.
You can give it a giggle every once in a while to make sure it's loose and free to move.
LS Tractor Owner
Super Member
- Joined
- May 1, 2017
- Messages
- 7,665
- Location
- Edgewood, NM
- Tractor
- LS XG3025 TLB, Previously MT125 TLB, Craftsman GTS6500
Yes, that is exactly what it is for! To break surface tension on any moisture or fluid inside the case and to allow it to drip out.
I had noticed the stray "cotter pin" a couple days after I got the tractor..... called the dealer and sent him a picture of it, leaving him a message asking if I could / should pull it out.. ...
He called me back within 2 minutes Immediately saying "DON'T pull it out !!" He then explained its use.
I had noticed the stray "cotter pin" a couple days after I got the tractor..... called the dealer and sent him a picture of it, leaving him a message asking if I could / should pull it out.. ...
He called me back within 2 minutes Immediately saying "DON'T pull it out !!" He then explained its use.
