MT125 customization

Mustangjames · Apr 28, 2019

Since the MT125 didn’t have a quick attach, I had to cut the brackets

and modify a Titan forklift attachment to work. Really get a lot of use out of this.

LS Tractor Owner · Apr 28, 2019

Nice job on both projects. Did you make a quick attach or is it still a pin on?

Mustangjames · Apr 28, 2019

It’s still a pin-on. I thought about building a QA plate but in the end decided I couldn’t think of another loader implement I really needed so just duplicated the attach structure on the back of the bucket. Also with this Titan forklift setup, you can remove the forks and insert other things into those brackets if i wanted to mount something.

Mustangjames · Jul 15, 2019

Had some vacation time so I built a quick attach for the FEL to fit the original bucket and the new forks. Not as smooth as a SSQA setup but it works pretty well. No comments on the welding.. some of these were work in process shots that got cleaned up later.

mslisaj · Jul 15, 2019

Nice job! Great ingenuity for sure.

LS Tractor Owner · Jul 17, 2019

Mustangjames said:
Had some vacation time so I built a quick attach for the FEL to fit the original bucket and the new forks. Not as smooth as a SSQA setup but it works pretty well. No comments on the welding.. some of these were work in process shots that got cleaned up later.

View attachment 613090 View attachment 613091 View attachment 613092

Very nicely done! Do you just pull 2 pins? Looks pretty easy to use.

Mustangjames · Jul 17, 2019

Yes. Top two pins stay in the bucket and you drive up, hook in, tilt back, then climb down and wiggle the bottom two pins in. Saw this design used on the small Kubotas and copied.