randy1959
New member
How do i change the seals in the cylinders?
massey fergesun 232 front loader
- Thread starter randy1959
- Start date
- Views: 14001
TractorTech
Elite Member
- Joined
- Jan 26, 2012
- Messages
- 3,109
- Location
- California
- Tractor
- Ford 7710, Ford 550, Ford 1910, Ford 4430, KD Forklift, Ford LGT17H, New Holland L255 Skidsteer
Here are some parts book pictures of the lift and bucket cylinders.
The lift cylinder has a locking wire on the gland nut that rolls out as the gland is loosened. Once the wire is pulled out, the gland can be pulled out.
The bucket cylinder uses a set screw on the gland to hold it in place. The screw is covered by a nylon plug. Once the set screw is backed out, the gland can be unscrewed.
Good luck. Hope this helps.
The lift cylinder has a locking wire on the gland nut that rolls out as the gland is loosened. Once the wire is pulled out, the gland can be pulled out.
The bucket cylinder uses a set screw on the gland to hold it in place. The screw is covered by a nylon plug. Once the set screw is backed out, the gland can be unscrewed.
Good luck. Hope this helps.
Here are some similar links:
