M7040SU underslung/downswept exhaust

   / M7040SU underslung/downswept exhaust
  • Thread Starter
#11  
Thanks DT86 and ovrszd.

DSCN0494.JPG

Might see if I can either do a couple of 90's to point down, or just get a straight pipe a few inches shorter than the factory one (it's about 5" too long and I don't want to cut it.......)
I don't want to modify the "normal" exhaust since I am fine with the upright pipe most of the time. It's only in the low door for the winter, but still has to come out for use.
 
   / M7040SU underslung/downswept exhaust #12  
I don't recall my elbow being welded on. Memory says it was clamped. Anyway, removed it and used a piece of the vertical pipe to build the sweep I wanted.

I think once you convert it you will not go back to the vertical pipe. I am never smelling exhaust fumes. Only time I even know it's there is if the tractor is running and I spend more than a few seconds at the chain box which is just above where the pipe dumps.

Not sure how handy it would be to go to a muffler shop??? But I'm guessing for $20 they'd build you a sweep for low exhaust. Then you could clamp your elbow back on if you wanted vertical again.
 

Tractor & Equipment Auctions

2018 Jaguar XE Sedan (A50324)
2018 Jaguar XE...
2015 Revere Shasta 27DB 5th Wheel Travel Trailer (A51694)
2015 Revere Shasta...
2019 FORD TRANSIT VAN (A52141)
2019 FORD TRANSIT...
TOW BEHIND FINISH MOWER (A50324)
TOW BEHIND FINISH...
Kubota SVL95-2 High Flow Cab Skid Steer (A52748)
Kubota SVL95-2...
2020 Ford F-150 4x4 Crew Cab Pickup Truck (A50323)
2020 Ford F-150...
 
Top