Loader leveling rod

[azranger]

I have a g3033 with the LL3102 fel. The bucket level indicator seems to be a little off, is there a way to adjust it. Tried loosening the bolts holding the rod and the sleeve , but neither one seemed to move.Any advice would be appreciated.

 

[Notforhire]

A photo would help. Is the stationary part of the indicator adjustable?

Bill

 

[blueriver]

I've never like them .. I just learn to watch the bucket.

 

[Guesseral]

I bent mine like a pretzel once just re-bent it an all was good. I don't think there is any real adjustment w/o just bending it to your needs. Like if you need the bucket to go down more for level you would have to flatten the V out some, if you had to bring it up to level you would have to close down on the V that would be a lot more difficult. Now if you don't have a V to show where level is then you have no idea what I am talking about, at that point disregard!

 

[azranger]

Thanks for the replies. I have tried to adjust the sleeve and the rod with no luck, mine does not have the v-notch, its just a straight rod. I will look at it alittle closer today when I have more time to play with it. Thanks again.

 

[Underdog57]

Thanks for the replies. I have tried to adjust the sleeve and the rod with no luck, mine does not have the v-notch, its just a straight rod. I will look at it alittle closer today when I have more time to play with it. Thanks again.

I have the straight rod on mine, it works good, I like it.

 

[altamaha]

On my 3039, the leveling rod is a two piece action... the inner rod is attached to the bucket and moves inside a sleeve as the bucket tilts... the outer sleeve is the part that is adjustable.. it is clamped at a stabilizing point and is adjusted by loosening the locking bolt, sliding the sleeve up or down, then re-locking the bolt.. hope this works for you.

 

[azranger]

On my 3039, the leveling rod is a two piece action... the inner rod is attached to the bucket and moves inside a sleeve as the bucket tilts... the outer sleeve is the part that is adjustable.. it is clamped at a stabilizing point and is adjusted by loosening the locking bolt, sliding the sleeve up or down, then re-locking the bolt.. hope this works for you.

Thanks altamaha, I will check that out, sounds like the same setup.

 

[azranger]

I do nit think it can be adjusted. I tried both ends and no luck.

 

[Guesseral]

I do nit think it can be adjusted. I tried both ends and no luck.


View attachment 364934

Ok I'll be dumb and ask. How does the rod tell you when the bucket is level with the ground? What am I missing?