chim
Elite Member
What kind of lighting are you working with that the drivers aren't integral with the lights?
I’m getting ready to install LED lights on my tractor. How did you route the wiring from the battery to the rops?I have these on my TYM T474, soldered in female 880 sockets to use with stock wiring. Nilights LED from Amazon.
View attachment 726054
Also, along with the led strips, you can try installing the wifi light bulbs on top of your tractor if you want the additional brightness. For example, you can set a yellow, which will be the additional pointer for drivers or people at night. You need to set the brightness level equal to the close lights' intensity not to distract other people and drivers. You can choose a high brightness level for the bulbs on top of the tractor.It is a good idea. If you want to install the led strips, buy ones with the proper software so you can set them correctly.
this"I unplugged the factory headlights and used the harness to power the LED's so I can use the factory light switch and not have to install a new switch on the dash. The factory headlights were close to useless."
I did something similar. I use the tractor on the road, so rather than blind oncoming traffic with the LED's, I kept the factory low beam headlights and they operate on the one detent on the factory headlight switch. The high beam wire controls the grille and side-mounted LED's instead of the factory high beams. The front and rear cab lights are controlled via two other switches in the normal spots in the cab roof.