Leaking steering box, John Deere 2030
- Thread starter Nedferd
- Start date
- Views: 359
-
- Tags
- john deere steering
gengine
Platinum Member
Are you talking about the valve in the console, or the "motor"? The steering valve ports, IIRC are o-ring boss. You need to use hydraulic o-rings that have a higher durometer rating than the cheap nitrile o-rings that cant handle the pressure. If your base gasket is leaking, either your return is plugged somewhere causing an over pressure situation in your valve, or you have a blown gasket. If its in the steering "motor", again, wrong o-rings, bad gasket, or plugged on the return side.
Harry in Ky
Veteran Member
Just ASSUMING here, this is what you have? Maybe the "base gasket" is #14? That's typically not a common leak. Not much reason for that gasket to fail. I'd look closer at O ring #15. Much more likely.
Tx Jim
New Member
Welcome to this forum
Return oil from power steering control valve on JD utility tractors of that era travels through hole in the mounting gasket back through a galley in clutch housing to trans reservoir.
Return oil from power steering control valve on JD utility tractors of that era travels through hole in the mounting gasket back through a galley in clutch housing to trans reservoir.
