L2800 L3400 Tool Box

[flyfisher1999]

Well I'm back and I like the cage. I have a couple of questions:

1) Where are you hanging the SMV sign and the hook for the top link?

2) How much weight (tool box) will the cage support?

 

[GMtb42]

Well I'm back and I like the cage. I have a couple of questions:

1) Where are you hanging the SMV sign and the hook for the top link?

2) How much weight (tool box) will the cage support?

When I took the picture it was not complete :
1. The SMV and holder will bolt up to back of cage on plate provided for them and the top link hook is mounted under the cage on support rods by plate provided for it .
2. I would say as much as you can put in a tool box the size pictured .

 

[tmar04]

could you fab up one of these to fit Yanmar YM2500? If so, what would the cost be? I can get you pics and meaurements if you like. let me know. thanks.

 

[GMtb42]

Finished design :

 

[GMtb42]

Harbor freight is selling some 16" toolboxes (quit a bit higher in price though) that are just a inch shorter and a inch less in width , I am making a cage for those as well .
This toolbox will actually put the top link holder in s better stop than the previous toolbox cage .

 

[nacl9163]

I got 4 super-strong flat magnets, & put them on top of the non-cup holder fender. Put what is essentially a bread loaf pan, the biggest I could find, on top of the magnets. This has never even come close to pulling off. I can fit a pocket saw, clippers, & 2 pairs of gloves with ease. I always put the clippers on top of the gloves and the magnets still grab, so I don't lose the gloves. Not huge carrying capacity, but better that nothing. A few more magnets and I could probably carry wrenches, screwdriver, etc. Also use the drain plug method for extra storage of things I don't use that often--rope, pry bar, etc.
L3400, FEL, post hole digger, bush hog