What kind of quick connect did kubota use before they went to the skid steer type? My dad's tractor has one that has a bar across the front of his loader that sets into a set of hooks on his attachments and then pins in at the bottom of the attachment. I need to build one that I can weld onto a plate that to fit my tractor. My New kubota has the skid steer type. Hope I'm not confusing everyone, but I would like to build one for my tractor so I can use his attachments. Thanks in advance
Kubota quick connect question
- Thread starter bulldog02
- Start date
- Views: 3524
amigauser
Veteran Member
What you describe I believe is the Kubota proprietary pin on type. They still use that type on the "B" series with their optional pin on bucket and pallet forks.
hr3
Veteran Member
ATI sells a pin setup for the B series,, 175.00 I think.. If you take that and weld it to a blank SS plate and you should have it,,
dirt clod
Gold Member
- Joined
- Jul 21, 2006
- Messages
- 331
- Location
- panama city and altha florida
- Tractor
- Kubota L3300, m5700, case 580se
For my m5700 you could get it with the bucket pinned on the arms, a kubota designed QD pinned on the arms, or a skid steer style QD on the arms. Mine was purchased used with a kubota Qd like you descibe. I would not look at getting a adapter plate to go between the two due to added stress but rather getting the kubota style pin on for your arms. I looked at getting the skid steer style disconnect to swap out on mine and it was reasonable priced. I would call kubota dealer with the model number of your loader as some of the tractors was available with more than one model loader.
countrybumpkin
Elite Member
- Joined
- Jun 14, 2005
- Messages
- 3,237
- Tractor
- Kioti, kubota
I priced a QC like the one your refering to from my local dealer and it was 240 dollars. It was the only one offered for mine, but I decided to build a SSQA for mine instead. As for plans for your dad's style just get all the measurments you need from his.
