laurencen
Veteran Member
- Joined
- Feb 19, 2007
- Messages
- 1,202
- Location
- saskatchewan Canada
- Tractor
- Bobcat Toolcat 5600T Kioti CK20, Cat D2 dozer, Cat 420 tractor loader, Deer 644E loader, Bobcat E32 mini and Bobcat 590 skidsteer, Toro Groundsmaster 325D
not a large project but since I picked up a Mule for the lake having a windshield is a must have, I looked at the factory and they are made of 1/4 plexiglass, the mounting is flimsy and I was quoted 1500 dollars, so went and picked up a sheet of 1/2 lexan, wanted a solid front, the 1/4 was too flexible spanning the 60 inches between the bars, I produce the half clamps of plastic for hydraulic cylinder supports just had to open them from 1 1/2 to 1 3/4 diameter
mounted the blocks on the frame, cut a cardboard template and jigsawed the main section to nest under the roof, the half inch was too heavy to bend and heating was not a option so again cut a template and sawed out the lower part, after fitting I routered all the edges 1/4 radius, mounted and applied a generous bead of silicone to both outside and inside of the joint
total cost just under 300 dollars, time 3 hours and its solid, the weight was around 40 pounds but doubt the machine will notice
thoughts
?
mounted the blocks on the frame, cut a cardboard template and jigsawed the main section to nest under the roof, the half inch was too heavy to bend and heating was not a option so again cut a template and sawed out the lower part, after fitting I routered all the edges 1/4 radius, mounted and applied a generous bead of silicone to both outside and inside of the joint
total cost just under 300 dollars, time 3 hours and its solid, the weight was around 40 pounds but doubt the machine will notice
thoughts
?
