Kioti 2610 Loader Arm Grease Fitting Bolts always loosening up

[IndyIan]

I lost a bolt on one of mine and then I couldn't find a proper length replacement, but I did have one that is a bit too long so it bottoms out in the hole before the head does and it stays fine. I think all the bolt does is keep the pin from turning, which a longer bolt does just fine. Looks wrong but it works.

 

[LHF2019]

Thanks for the replies. I'll try some red LocTite or see if I can safety wire them somehow.

Appreciate the replies.
Lou

No red. Blue blue blue. You just need a little bit.

 

[YLee Kioti]

If using loctite the threads must be free of any oil or grease. If oil on threads the loctite typically will not setup and harden properly.

In case one may not be aware but there are two types of blue loctite.
242 and 243......I use the 243 because I am truly lazy but on occasion to clean up and wipe away oils and grease prior to using it.
A few shots of brake cleaner then assembly and large bugger drops of 243.
Here is a thread on the topic. for a deeper look-see.

And as mentioned once IF the bolts have / may have been over tightened; then I would get new bolts, clean threads, even consider a thread chaser, then use the blue 243 and snug tight or toque specs of available.

Loctite difference 242 vs 243 ??? - HeliFreak
This thread discusses the two types, 242 and 243.

When I rebuilt the FEL cylinder for the 2d time, bolt removal was a bit tough. Hammer fist the 3/8 ratchet, which means the 243 is working well. Because I did not bear down on it during the first rebuild- reinstall but snugged it up until there was no more 'forced' movement.