John Deere 6405 won't move and pto does not work

[RyanMire]

I was bush-hogging and the hydraulic return line that goes to the filter blew off. I repaired it and added oil back to the tractor, now it will not move nor will the pto work. The 3 point, hydrolic remotes and steering all work at this time. Any ideas??

 

[TBN Support]

Welcome to the forum. :welcome:

I'm going to move your thread over to the John Deere section to see if we can find you some answers.

 

[beenthere]

Also, welcome to TBN

How much oil did you have to add? And what oil did you add? We'll try to help you out..

 

[RyanMire]

Also, welcome to TBN

How much oil did you have to add? And what oil did you add? We'll try to help you out..

I added 7 gallons of the premium hydraulic oil from tractor supply.

 

[Tx Jim]

:welcome: to TBN
Sounds as if you might have an electrical problem. Have you checked wiring & fuses?

 

[Zebrafive]

I added 7 gallons of the premium hydraulic oil from tractor supply.

I doubt the oil is the problem, but I do not think TSC oil meets JD's specs (HyGard specs)

:welcome: to TBN
Sounds as if you might have an electrical problem. Have you checked wiring & fuses?

I was thinking the same thing, if a hose pulled off, maybe wires or a connector pulled apart.

 

[RyanMire]

I doubt the oil is the problem, but I do not think TSC oil meets JD's specs (HyGard specs)



I was thinking the same thing, if a hose pulled off, maybe wires or a connector pulled apart.[/

I check ,no wire came unconnected or fuse blown.