John Deere 3255 Loader Plumbing

[BCMac]

Bringing this thread back from the almost dead. I finally managed to land a 260 with the right mounting frames, valve, joystick etc at auction.

Needs a bit of work. Mainly a couple of the fastening pins on the pivots are either cobbled back together or replaced with a hitch pin.

Does anyone make 3rd party replacement parts for these loaders? JD has some of the parts I would like to replace like those pin fasteners (W31823) and the snap rings (W33880). They want about $90 per pin and don't have some items like the spacers (W35518) anymore.

 

[Tx Jim]

It's difficult to imagine parts cost that much more above the 49 parallel. W31823 is $56.62USD

 

[Zebrafive]

It's more the Canadian dollar verses the US dollar

 

[Tx Jim]

One would think with the way USA politicians have been printing/giving away $$$$$$ that it would be the other way!!

 

[beenthere]

Bringing this thread back from the almost dead. I finally managed to land a 260 with the right mounting frames, valve, joystick etc at auction.

Needs a bit of work. Mainly a couple of the fastening pins on the pivots are either cobbled back together or replaced with a hitch pin.

Does anyone make 3rd party replacement parts for these loaders? JD has some of the parts I would like to replace like those pin fasteners (W31823) and the snap rings (W33880). They want about $90 per pin and don't have some items like the spacers (W35518) anymore.

Having a machine shop make you some pins and spacers likely be cheaper.
Or anyone you know that has a lathe?

Are the hitch pins the wrong diameter? Prolly buying the part is one reason the FEL is cobbled together. What diameter pins do you need? and spacer size?

 

[BCMac]

Even with the exchange, that should only be about $70 CAD. Fortunately I don't need to replace them all, just 2 or 3. The spacers I will have fabbed in town next time I get a chance to go in.

 

[BCMac]

One would think with the way USA politicians have been printing/giving away $$$$$$ that it would be the other way!!

Oh man, you think you guys have been printing money. Check into what our PM has been up to.