I have a 4500 with 1900 hours that would start or take a jump. Replaced battery and the thing fired right up and ran for 10 minutes while I put all the body parts back on. Turned it off for a few minutes to fuel it up and now can't get to turn over.... Unit is in neutral and I have power - but the unit will not turn over. Gets lots of clicking in the engine bay /console - but can't figure out. Pulled and check all regular fuses. Any thoughts?
JD4500 Wont Start
- Thread starter AZBrad99
- Start date
- Views: 1145
-
- Tags
- john deere 4500
Tx Jim
New Member
Welcome to TBN
I suggest to clean/tighten battery ground cable where it attaches to tractor frame.
I suggest to clean/tighten battery ground cable where it attaches to tractor frame.
bearthebruce
Platinum Member
- Joined
- Jul 26, 2018
- Messages
- 552
- Location
- Property is in Floyd County VA
- Tractor
- '05 Massey Ferguson 1533; '22 LS MT125, '23 Kubota SVL65-2
also check any relays in the starter circuit. Perhaps the relay is not pulling in fully, providing the proper path to pull in the starter solenoid. Do you have a wiring diagram?
Is there something loading the battery and discharging it? with Key off, there should be little to no draw from the battery.
Is there something loading the battery and discharging it? with Key off, there should be little to no draw from the battery.
will do -thx
Here are some similar links:
