JD 6410 how do you remove this?

[hozjob]

I took the 8 bolts out, and removed the snap ring. But it doesn't budge and don't want to force anything I'm not supposed to. Pic to follow

 

[DLTTrekkers]

See if 2 of the holes have thread in it ? Use 2 of the 8 bolts and jack if off its axle

 

[DLTTrekkers]

I took the 8 bolts out, and removed the snap ring. But it doesn't budge and don't want to force anything I'm not supposed to. Pic to follow

sorry....not axle.....dowls !

 

[LouNY]

Attached is a parts breakdown it may be #6 or you may have to remove the knuckle and disassemble from the backside
John Deere - Parts Catalog
It looks like this link isn't going to the correct model, change model from 310 to your 6410, then sectional index then front axles then knuckle housing.
I know on the NH's the axle bearings are from the backside of the knuckle housing.

 

[pmsmechanic]

Do you need to push it in a little (1/8 - 1/4")? Sometimes there are hidden snap rings holding parts together.

 

[retro7570]

dowels around axle have loctite on them, heat dowels to 400 degrees then I made a puller to remove gear.

 

[banjodunn]

G'day tight fit from memory but a thin wedge on opposite sides should work without damaging anything


Jon

 

[hozjob]

Thanks everyone!! A bit of heat, the threaded holes and a puller made quick work of it.