If you have Toolcat questions, ask them here...

[geeque]

I am not sure about this as my 2013 toolcat does not show me service reminders?

Have you tried pressing the light switch (the one you use to show codes)? That shows codes and may clear them?

That didn't work, thanks anyway.

 

[geeque]

What Series is it?

I never saw any on our 5610 series F.

I don't see anything about series on the machine or the manual. Where would I find that?

 

[Xfaxman]

I saved this from SSdoxie in a post from 2014:

 

[geeque]

Nice work Xfaxman. I'm a D series on the 5600.

 

[Xfaxman]

Thanks.

There are some manuals available on eBay: bobcat 694791 | eBay

 

[geeque]

I have that manual and nothing. I have talked to the Bobcat dealer in my area as well as Bobcat central where ever they may be and no one has the answer.

 

[SSdoxie]

The service reminder clock is a feature built into the Deluxe (keyless) panel. That is where it started but now may be in all, I do not know for sure. This is an option that can be turned on and time intervals can be set to owners preference. It is not turned on or times set from the factory. Turning it on and setting use hour preference can only be done with the dealer's PC and software. Instructions to reset the timer should be found in the Operator Manual in setup and use of the Deluxe Panel, towards the back of the book.

I can't remember the exact sequence to reset it, but do recall it was holding down 2 buttons. With the panel on and code displayed try holding down the push for code and work mode button at same time and hold them down for 10 - 15 seconds.

 

[geeque]

The service reminder clock is a feature built into the Deluxe (keyless) panel. That is where it started but now may be in all, I do not know for sure. This is an option that can be turned on and time intervals can be set to owners preference. It is not turned on or times set from the factory. Turning it on and setting use hour preference can only be done with the dealer's PC and software. Instructions to reset the timer should be found in the Operator Manual in setup and use of the Deluxe Panel, towards the back of the book.

I can't remember the exact sequence to reset it, but do recall it was holding down 2 buttons. With the panel on and code displayed try holding down the push for code and work mode button at same time and hold them down for 10 - 15 seconds.

Thanks again, but still no luck.

 

[SSdoxie]

Thanks again, but still no luck.

Try holding down the code button and the AUX button simultaneously.

 

[geeque]

Try holding down the code button and the AUX button simultaneously.

Nothing.