laurencen
Veteran Member
- Joined
- Feb 19, 2007
- Messages
- 1,143
- Location
- saskatchewan Canada
- Tractor
- Bobcat Toolcat 5600T Kioti CK20, Cat D2 dozer, Cat 420 tractor loader, Deer 644E loader, Bobcat E32 mini and Bobcat 590 skidsteer, Toro Groundsmaster 325D
around my acerage wanted a forklift, had a small Toyota 3000 pound lift but it was a bummer in the yardso traded it for a Hyster diesel old machine
thinking its a D50 will get a few pictures and hopefully someone can help identify.
this thing runs not bad, 3 stage but a low mast the issue was no brakes so a project and so it begins
removing duel wheels was a chore, outside wheels are held on by nuts, the nuts are threaded onto spuds that then hold the inside wheels, both inside wheels are flat, valve stem is not accessable from outside. have 4 of these spuds with nut stuck on the wheels, not sure how to get them aoart at this time
after removing the wheels, then a carrier bolted to hub you remove the drum, then the spindle those cone washers were a pain removed the bearing nuts anf finally the hub, the inner brake parts were rusted solid, plus backing plate was rotted thro in places.
finally after a week I have the left side back together I can start the right side, this I will take some pictures as it progresses
looking back 2 weeks in should have kept the Toyota
thinking its a D50 will get a few pictures and hopefully someone can help identify.
this thing runs not bad, 3 stage but a low mast the issue was no brakes so a project and so it begins
removing duel wheels was a chore, outside wheels are held on by nuts, the nuts are threaded onto spuds that then hold the inside wheels, both inside wheels are flat, valve stem is not accessable from outside. have 4 of these spuds with nut stuck on the wheels, not sure how to get them aoart at this time
after removing the wheels, then a carrier bolted to hub you remove the drum, then the spindle those cone washers were a pain removed the bearing nuts anf finally the hub, the inner brake parts were rusted solid, plus backing plate was rotted thro in places.
finally after a week I have the left side back together I can start the right side, this I will take some pictures as it progresses
looking back 2 weeks in should have kept the Toyota