Question is about top link eyes. I can get a Hydraulic cylinder w/ swivel eyes way cheaper than I can with one set up as a top link already. The only difference is the ears/spacer sticking out. Does it really matter if I go the cheaper route First cylinder has bearing eyes with Grease Zarks, listed as swivel eyes. The other has no Grease Zerk but is built like a top link. Does it really matter?
Hydraulic top link
- Thread starter Pouldeaux
- Start date
- Views: 928
workinonit
Elite Member
Those won't fit on the tractor side.
workinonit
Elite Member
At least they won't fit on a 5 series JD.
/pine
Super Star Member
- Joined
- Mar 4, 2009
- Messages
- 15,763
You can grind the sleeves down flush with the eye...I had to do this so the cylinder end would fit between the flanges on the tractor end of my top link...likewise on the implement end for some attachments...
Xfaxman
Super Star Member
- Joined
- Feb 8, 2013
- Messages
- 13,311
- Location
- Guthrie, OK
- Tractor
- Toolcat 5610 G - Bobcat V417 - TORO+Loader
What really matters is the diameter of the hole, retracted length and stroke length.
Is it because the eye OD is to big around
