I bought a 2016 2032 while back with 50 hours on it..very pleased with tractor, but one thing I dont like is how the hydraulic hoses to the FEL hang down on the right side below the floor board. I've been using it in the woods taking out dead trees and worry about the hoses hanging up on something. Looks to be a bad design. Has anyone remedied this?
Hydraulic hoses
- Thread starter Glynnb
- Start date
- Views: 1812
/pine
Super Star Member
- Joined
- Mar 4, 2009
- Messages
- 15,763
Can you not zip tie them together and up tight against something leaving just enough room for needed flex?
They also make spiral cut shielding armor that is large enough to cover several smaller (loader like) hose bundles...
They also make spiral cut shielding armor that is large enough to cover several smaller (loader like) hose bundles...
beenthere
Super Star Member
- Joined
- Aug 16, 2001
- Messages
- 18,648
- Location
- Southern Wisconsin, USA
- Tractor
- JD_4x2_Gator, JD_4300, JD_425, JD_455 AWS, added JD_455, JD_110, JD_X485(sold)
That problem is apparently one of the upgrades when the 2017 2032 was produced. Any possible way to incorporate the new style plumbing?
kennyd
Advertiser
This is a bad internet picture, and one from JDParts that shows the part number, but you should have a metal loop mounted to the floorboard to support the hoses.
kennyd
Advertiser
It's in the wrong place.
beenthere
Super Star Member
- Joined
- Aug 16, 2001
- Messages
- 18,648
- Location
- Southern Wisconsin, USA
- Tractor
- JD_4x2_Gator, JD_4300, JD_425, JD_455 AWS, added JD_455, JD_110, JD_X485(sold)
The hoses can be turned to go straight forward and bungied into place, and agree with kennyd that the loop is mounted wrong.
Place them where the colored lines lie. Could also run the bundle through a short section of 2-3" pvc pipe for more brush protection. Tie the excess hose loop up in the FEL where it should be out of the way.
Attachments
beenthere
Super Star Member
- Joined
- Aug 16, 2001
- Messages
- 18,648
- Location
- Southern Wisconsin, USA
- Tractor
- JD_4x2_Gator, JD_4300, JD_425, JD_455 AWS, added JD_455, JD_110, JD_X485(sold)
As long as you are happy, that's all that really matters.
I'd have them up higher, no lower than the connectors. And have the male/female caps snapped together to keep out dust and dirt so it doesn't contaminate the hyd. oil in the system.
I'd have them up higher, no lower than the connectors. And have the male/female caps snapped together to keep out dust and dirt so it doesn't contaminate the hyd. oil in the system.
kennyd
Advertiser
The hoses need to be that long to allow you to take the loader off.
goeduck
Super Star Member
You have a broken spoke on that wheel in the background 
Here are some similar links:
