Help... cannot get input shaft back into clutch...

[94BULLITT]

I am not sure about an inspection hole,you think I might get something in there to stop or move inner shaft.
Thanks
Ken

You might be able to if you have one.

 

[Soundguy]

so is this really a dual clutch.. sounding more and more independent single, witht he pto run direct thru

 

[Kenonf]

Okay, Finally got back from a job and picked up a couple of parts at the dealer. It is together, I took a little time and watched my alignment. I also removed the gantry crane and put the front and back halves on floor jacks. Every thing else went on easy, finished in about 4 hours. I have run it and no more sticky input shaft. I leave for another job soon and when i get back will remount the middle loader supports, and re install the front loader. With any luck I will be able to level the bucket, after I found out now loose the frame bolts were.
Thanks for the help guys.
Ken

 

[Soundguy]

awesome deal!

 

[Chilly807]

Glad to hear it's back together and working. Sounds like the rust was the culprit.

Sean

 

[94BULLITT]

I wondered if you ever got it back together. You are supposed to periodically check the loader bolts and wheel nuts/ bolts.