GT275 deck adjustment

   / GT275 deck adjustment #1  

lonesouth

New member
Joined
Apr 10, 2010
Messages
2
I've been searching for a bit and can not find a definitive guide for how to level the deck on my GT275. It is the stock 48" deck. My issue is that even in the transport position, it is cutting too low. Hoping one of you can point in the right direction for getting this back to spec. The front axle was replaced about two years ago at a JD dealer, I am unsure if they correctly reinstalled the deck.
 
   / GT275 deck adjustment #2  
Steps to "level" deck,
first, air the tires to correct pressure and get on flat surface.
Then lift deck wheels so they are up out of the way.
Then set height to 2 inches on lift.
Then with blades aimed straight out left and right, adjust the tips to 2" so they are the same as the height setting. (this is accomplished by adjusting the lift turnbuckles on each side).
Then turn center blade to point forward and measure height to flat surface. Set the front tip to be 1/8 to 1/4" less than the rear tip by adjusting the front bail if needed.
Then set the lift lever to the cutting height you want, and lastly set the deck wheels to be just free to turn at the cutting height.
:welcome: to TBN
 
   / GT275 deck adjustment
  • Thread Starter
#3  
very much appreciated!
 

Tractor & Equipment Auctions

KODIAK 10' HD ROTARY MOWER (A51406)
KODIAK 10' HD...
2006 GMC C8500 Altec AM547 50ft Material Handling Insulated Bucket Truck (A50323)
2006 GMC C8500...
4 1/2 150G DRILL STEM 358 JOINTS (A50854)
4 1/2 150G DRILL...
2013 POLARIS RANGER 800 EFI UTV (A51243)
2013 POLARIS...
2006 CHEVROLET SILVERADO 4X4 PICKUP TRUCK (A51222)
2006 CHEVROLET...
John Deere 4520 Tractor (A50514)
John Deere 4520...
 
Top