grease gun accident

[Redneck_Randy]

be careful removing your grease gun tip from a zert. mine got stuck and when it came off my hand went flying back and hit the FEL brace. picture tells it all.

Randy

 

[Redneck_Randy]

be careful removing your grease gun tip from a zert. mine got stuck and when it came off my hand went flying back and hit the FEL brace. picture tells it all.

Randy

 

[RobS]

Yikes, major bummer!!! I can relate as I serviced my backhoe and loader just yesterday. Why isn't there a grease tip with a slide collar that releases easily when pulled back?

Broken? How bad? You can print off all the TBN signatures and stick them on /forums/images/graemlins/smile.gif

 

[RobS]

Yikes, major bummer!!! I can relate as I serviced my backhoe and loader just yesterday. Why isn't there a grease tip with a slide collar that releases easily when pulled back?

Broken? How bad? You can print off all the TBN signatures and stick them on /forums/images/graemlins/smile.gif

 

[texasjohn]

OOF /forums/images/graemlins/crazy.gif Am sure that hurt!!!

Hope all recovery goes well..... and that you are soon back in the seat again!

 

[texasjohn]

OOF /forums/images/graemlins/crazy.gif Am sure that hurt!!!

Hope all recovery goes well..... and that you are soon back in the seat again!

 

[AchingBack]

Removing a grease gun tip from a zerk is a different technique than attaching to the fitting. When attaching, one pushes the tip dead-on in order to make the seal. After applying the grease though, you should grasp the tip and pry it off with your hand if you are using a flex hose. If using a fixed fitting, then you can just pry the fitting off by moving the gun at an angle. I have the Lincoln pneumatic gun, and this works well for me. I believe most tips have a strong spring of some type that needs to grasp the zerk in order to seal tightly. A buildup of old grease will cause the tip to get stuck, as will a piece of fine grit.

May God speed your healing,
AB

 

[AchingBack]

Removing a grease gun tip from a zerk is a different technique than attaching to the fitting. When attaching, one pushes the tip dead-on in order to make the seal. After applying the grease though, you should grasp the tip and pry it off with your hand if you are using a flex hose. If using a fixed fitting, then you can just pry the fitting off by moving the gun at an angle. I have the Lincoln pneumatic gun, and this works well for me. I believe most tips have a strong spring of some type that needs to grasp the zerk in order to seal tightly. A buildup of old grease will cause the tip to get stuck, as will a piece of fine grit.

May God speed your healing,
AB

 

[755inNY]

<font color="blue"> A buildup of old grease will cause the tip to get stuck, as will a piece of fine grit.
</font>

I've also found that pressure from the grease will make it more difficult to remove the grease gun. When I've had a stuck fitting, I found that waiting a bit to allow the pressure to relax allows for easier disconnect.

Jeff

 

[755inNY]

<font color="blue"> A buildup of old grease will cause the tip to get stuck, as will a piece of fine grit.
</font>

I've also found that pressure from the grease will make it more difficult to remove the grease gun. When I've had a stuck fitting, I found that waiting a bit to allow the pressure to relax allows for easier disconnect.

Jeff