Good morning!!!!

[Wagtail]

June Full Strawberry Moon.

Which is being reported here as it's the first occasion for this full moon in 19 years... confusing though as this is the opposite season for strawberries to be in 'season' for me.

 

[Looking4new]

Good morning, the low is 52 and going to a high of 68°F. Wind SW 11 mph. 70% chance of showers.

Another energy conservation day.

Safe travels Drew.

Nice moon although thanks to the pesky Western Canadians a little smoky.

Have a safe day all

 

[wngsprd]

63 to 88...but less humidity. Would go to the mountains, but their forecast is "Widespread Haze" which I have never seen on the NWS site. I think their particulate count is high due to the Canada smoke at higher elevations.

Beautiful sunrise pic, ganzer.

Roasted 3 coffees yesterday. Drinking a real good one today from Chiapas, Mexico, next to Guatemala. I'll try the Rwanda coffee tomorrow.

 

[m7040]

good morning, 61 going to 81 sunny

Mowed a couple of areas and managed to not get stuck in the wet areas.

Finishing the wall in the barn. Nothing is square or level so involves lots of shimming and stub outs

 

[Thomas]

53F partly cloudy day mid 70's for high.

Outside chores done E muffin time.
Plans for today...take trimmer for long walk afterwards putter.

Enjoy your day all.

 

[Buppies]

58 this morning high in mid 80s

Work started on new job see how that goes

Did not sleep well but such is life. Grass getting really tall might do something about that.

Hope trip goes smoothly Drew

Prayers for all silent or spoken our Country

 

[Buppies]

Great picture of moon Ron

 

[Happy in NC]

Good morning TBN!!
55 this morning and should be upper 80s and dry later with a little less humidity.

Missed posting yesterday but you didn't miss much as it was minor bridge time and R7R the rest of the day.
Yesterday the guy that helped me cut the new tank came out to pick up the steel we cut out to cover and permanent bury old septic. They bought the house we owned for years when we built this place.
Then hand work picking up the left overs from the 2 loads of rip rap and getting them on the bridge. This body is getting to old for that kind of work.
Also on the agenda is getting stuff put away and regrouping.
Also I need to crawl under the NH TC to see what it takes to replace the oil pan gasket (I hope) been feeding it every morning with oil and it's getting worse. Hopefully it is pretty straight forward. Anyone know of any "gotchas" I need to look out for? Like splitting the tractor or something.
Rest of the day will be puttering to rest back and arms a little

Time for a second cup
Everyone have a great and safe day!!

 

[ronjhall]

Also I need to crawl under the NH TC to see what it takes to replace the oil pan gasket (I hope) been feeding it every morning with oil and it's getting worse. Hopefully it is pretty straight forward. Anyone know of any "gotchas" I need to look out for? Like splitting the tractor or something.
Rest of the day will be puttering to rest back and arms a little

What appears to be an oil pan gasket. Many times is a rear engine seal failure. Then tractor will need to be split. Not a fun task.

 

[Happy in NC]

Thanks! Seems to be the front of the pan. I'll start it's own thread after I get under for a closer inspection. I have trace leak but haven't used it yet. Expensive stuff! I haven't added it yet. I'll give it a bath first