wngsprd
Super Member
Took Della on a hike and cool off swim yesterday afternoon.
Never seen a light fixture like that...very interesting.Morning all!
55 going to a raining 72.
Got the cabinet installed in the bathroom Saturday. While I was there I removed the tub drain and cleaned it all out so it drains now!
Pic of install with new light.
View attachment 884810
That should be it now for this room!
Delivered the second wagon wheel that I repaired. Wagon has fallen off it's blocks and now needs floor work!! Brother says he will drop off the whole thing to my house once it is movable again.
Working at a different sister's house today if I can beat the rain. Needs storm gutter cleaned and a few other odds and ends.
Didn't do much yesterday but visit a little and enjoy our front porch. We did take a ride in the afternoon.
View attachment 884813
Small project done in the wood shop this week. Little ring box made out of a scrap/burl of apple.
View attachment 884816
That's it for now. I need more coffee!
Hope everyone stays safe and healthy!
Google is your friend, but it never hurts to exercise the old noodle.My conversion from kilometers to miles is (?)meters times 39 (there are 39 inches in a meter) divided by 12 (12 inches to the foot) divided by 5280 (feet in a mile). There is a shorter formula but I can never remember it.
eg; 32 kms is 32000 meters x 39"= 1,248,000 inches divided by 12= 104,000' divided by 5280 feet in a mile=19.696969 miles or rounded up to 20 miles.
@WoodChuckDad put in a similar unit. He sometimes drops on this thread. I don't think he has hooked up his loops yet though, thinking just his hot water.
I know my system still in my basement just has a water fill valve, an air scoop (I think it's called, that removes air from the line) with a small pressure tank above it. my circulator pump was on the boiler, and I put in zone valves, that I never could get to work. basically the zone valves took 12V signal to open when thermostat called for heat. I used a 12V relay that triggered when thermostat called for heat, with a stronger 12V supply to power the zone valve.
1" output line to air scoop & expansion tank, then it splits to two 3/4" each with a zone valve.
View attachment 880246View attachment 880247
water makeup valve goes into return line, and circulator pump on input to boiler.
He’s got it plumbed, but not sure if he’s fired it up yet. Look back about 2 weeks agoI’m late to the party. This just popped up on my feed of topics. Is there a thread talking about his boiler setup? Is he already done and all is well?
I was sitting down for a quick late lunch. I broke a blade off my Ventrac and can’t find it. Getting ready to take my metal
Detector out there and see if I get lucky