FX24D issues
- Thread starter coolbrze
- Start date
- Views: 4076
runningbird
Gold Member
is the 3pt dropping a bit then suddenly raising?
normde2001
Elite Member
- Joined
- Mar 10, 2002
- Messages
- 4,163
What do you mean by "running"? Is it moving, just sitting idling, hydraulics working?
Yes but the entire tractor kinda "pulsates"
When it's sitting idling still although may do it when moving but if so, it's harder to notice but I'll pay more attn. next time I drive it. Hydraulics work but bucket doesn't stay up very well once you put weight in it...
runningbird
Gold Member
does the 3pt stay up when the tractor is off?
YanmarFever
Elite Member
- Joined
- Mar 10, 2002
- Messages
- 3,367
- Location
- Eating a melon..
- Tractor
- Mahindra 5010C- Branson 4520r- 5520C- Yanmar FX235-D - Bad Boy rogue mower
1. Have you cleaned the Hydraulic filter screen lately? Its located on the under side of the machine
2. Also it sounds like your 3 point adj arm is out of adjustment, did you turn on it with a wrench where it comes out of the tractor top end?
3. Did you turn the 3 point adj knob, its located right between your ankles when seated on the tractor.
4. Do you have the correct hydraulic filter installed, ( if not) it will pulsate because its not circulating enough fluid.
Lots of questions...
2. Also it sounds like your 3 point adj arm is out of adjustment, did you turn on it with a wrench where it comes out of the tractor top end?
3. Did you turn the 3 point adj knob, its located right between your ankles when seated on the tractor.
4. Do you have the correct hydraulic filter installed, ( if not) it will pulsate because its not circulating enough fluid.
Lots of questions...
Sorry for the delayed reply, been busy working. No the 3 point hitch goes down almost immediately when I turn the tractor off but the FEL stays up.
YanmarFever
Elite Member
- Joined
- Mar 10, 2002
- Messages
- 3,367
- Location
- Eating a melon..
- Tractor
- Mahindra 5010C- Branson 4520r- 5520C- Yanmar FX235-D - Bad Boy rogue mower
Have you checked the 4 things mentioned in the post above?
kenmac
Super Member
- Joined
- Feb 13, 2005
- Messages
- 9,835
- Location
- The Heart of Dixie
- Tractor
- McCormick CX105 Kubota MX 5100 HST, Kubota ZD1021, Kawsaki Mule 4010 trans 4x4
my 3110 does this. I think it's the 3 point valve. I haven't replaced it yet. Last I checked, they didn't have any