3-Point Hitch Ford 3400 3 point problem

   / Ford 3400 3 point problem #1  

snorulz

New member
Joined
May 11, 2009
Messages
7
Hello,

I have a Ford 3400 and the 3 point hitch is acting up. The hitch will only go all the way up or all the way down, you can't get it to do anything in between even if you only move the lever just a little bit. What would cause this problem?

Thanks
 
   / Ford 3400 3 point problem #2  
Does the tractor have a selector for either Position Control or Draft Control? It sounds like you may have inadvertently selected Draft Control. In draft control, the implement only raises slightly as the tractor senses a change in plowing depth. This is normally sensed by toplink compression. The hydraulic lift either raises the implement or drops it all the way as you indicated in your post.

If you have position control selected, you could have something broken or out of adjustment causing the 3PH to only respond as it would in draft control. I don't have specific knowledge of your tractor to give you any more advice than that.
 
   / Ford 3400 3 point problem
  • Thread Starter
#3  
It does have the option for draft control but i tried the lever in both spots and it seems to act the same.
 

Tractor & Equipment Auctions

2018 Toro Sand Pro Bunker Rake with Edger Broom (A49461)
2018 Toro Sand Pro...
2015 DODGE RAM 1500 CREW CAB TRUCK (A51406)
2015 DODGE RAM...
2017 Bad Boy Outlaw XP 61in Zero Turn Mower (A48082)
2017 Bad Boy...
2016 HITACHI ZAXIS 210LC-6N EXCAVATOR (A51242)
2016 HITACHI ZAXIS...
2019 FORD F-150 XL SINGLE CAB TRUCK (A51406)
2019 FORD F-150 XL...
2020 KUBOTA RTV X1100C UTV (A51406)
2020 KUBOTA RTV...
 
Top