ruffdog
Super Star Member
- Joined
- Dec 31, 2011
- Messages
- 12,463
- Location
- southern wisconsin
- Tractor
- Bobcat Toolcat 5610G, Deere X744, Cub Cadet IH 982
Here is the socket I used.
Ford 1920 antifreeze leak at block fitting
5030
Epic Contributor
- Joined
- Feb 21, 2003
- Messages
- 28,967
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
WD40 is basically worthless as a penetrant. All it's really good for is water displacement. Blaster is much better and a mix of red ATF and acetone is even better and cheaper.
Awesome and thanks for the advice fellas. Will tackle this as soon as I can find a replacement fitting. Any help identifying what to look for and where? Ditto on the ATF. Been fixing up my old 96 tacoma the last 6 months and ATF certainly has helped on plenty of threads.
Last edited:
Well I guess I was searching the wrong terms. Found some more info for what appears to be a common problem. Sorry for all the questions folks and thanks again for the advice.
www.tractorbynet.com
Engine Coolant Drain-Plug Leak
For all Ford and NH Tractor Owners with the infamous leaking block! I put up with it for years on my Ford 1720 and for almost 4 on my TC 40D. I tried several fixes, including new plugs, teflon tape, blue silicone sealant, pipe dope, etc, all to no avail. ...But, I think I've got it by-golly...
www.tractorbynet.com
ruffdog
Super Star Member
- Joined
- Dec 31, 2011
- Messages
- 12,463
- Location
- southern wisconsin
- Tractor
- Bobcat Toolcat 5610G, Deere X744, Cub Cadet IH 982
Perfect. Thank you!Well I guess I was searching the wrong terms. Found some more info for what appears to be a common problem. Sorry for all the questions folks and thanks again for the advice.
Engine Coolant Drain-Plug Leak
For all Ford and NH Tractor Owners with the infamous leaking block! I put up with it for years on my Ford 1720 and for almost 4 on my TC 40D. I tried several fixes, including new plugs, teflon tape, blue silicone sealant, pipe dope, etc, all to no avail. ...But, I think I've got it by-golly...
mrmikey
Elite Member
If you can't find an all in one fitting:
MTGreen
Platinum Member
- Joined
- Oct 12, 2022
- Messages
- 999
- Location
- Montana, USA
- Tractor
- Deere 5220, Ford 1720, Deere Progator 2030
I'm also a big fan of red atf 50:50 with acetone. I put it in one of these and use the compressor - never going back to liquid wrench or pb blaster
5030
Epic Contributor
- Joined
- Feb 21, 2003
- Messages
- 28,967
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
I'm cheap, I use a plastic spritz bottle...lol
Tackled the fitting this afternoon. Cut the hose barb part off so I could get a socket on it with a long handle ratchet. ATF and acetone for a bit and it broke loose. Sort of creaked a few times then spun out clean. Took maybe 30-45 minutes total. Cleaned the area up a little, ran tractor for a while and found no leaks. Thank you for all the advice fellas.
