RFischer
Silver Member
Where did you buy your grease gun and the moly grease? Who has the best prices? /w3tcompact/icons/smile.gif
FEl Grease Zerks
- Thread starter Turfman
- Start date
- Views: 2131
B7500
Platinum Member
My loader manual says to use a high quality grease designating "extreme pressure"
Should I not use Walmart grease?
-T
Should I not use Walmart grease?
-T
dgood1
Silver Member
My opinion is that there are probably only a few manufacturers of all of the brands out there. I would guess that WalMart uses one of the major oil companies to supply the grease with the WalMart label on it.
My best guess would be that as long as the specifications are the same there would be no problem. I think that the main thing is the frequency of the greasing. By putting in new grease you drive out the metal dirt and moisture that has accumulated in the bearing areas.
I personally grease untill I see the grease come out without any discoloration, then I opperate the FEL and give each zerk another couple of shots. It is also a good idea to wipe the zerks off before greasing so that no dirt gets pushed into the area that you are greasing.
Just my opinion though,
Don
My best guess would be that as long as the specifications are the same there would be no problem. I think that the main thing is the frequency of the greasing. By putting in new grease you drive out the metal dirt and moisture that has accumulated in the bearing areas.
I personally grease untill I see the grease come out without any discoloration, then I opperate the FEL and give each zerk another couple of shots. It is also a good idea to wipe the zerks off before greasing so that no dirt gets pushed into the area that you are greasing.
Just my opinion though,
Don
nnicklas
New member
I purchased a couple tubes of extreme pressure grease from Pep Boys. I purchased a new grease gun from nothern tool. (It was cheaper than pep boys even with shipping.)