jakieboy
New member
- Joined
- Nov 10, 2017
- Messages
- 5
- Location
- Stevensville, Montana
- Tractor
- 1948 International Farmall cub
How do I test the condenser and the coil? Tractor has a J4 magneto.
Farmall Cub questions
- Thread starter jakieboy
- Start date
- Views: 9362
-
- Tags
- farmall cub
Looking4new
Super Member
- Joined
- Apr 8, 2012
- Messages
- 9,967
- Location
- Northern Ontario, Canada
- Tractor
- 2012 Kioti CK27HST w/cab
Try this site.
Testing an Ignition Coil with a DVOM - Farmall Cub
Testing an Ignition Coil with a DVOM - Farmall Cub
OP
jakieboy
New member
- Joined
- Nov 10, 2017
- Messages
- 5
- Location
- Stevensville, Montana
- Tractor
- 1948 International Farmall cub
I appreciate the answer you gave, however my cub has a j4 magneto with an internal coil that doesn't have the two wire set up you have shown. how do I test my coil?
additionally how do I test for a bad condenser?
Last edited:
Looking4new
Super Member
- Joined
- Apr 8, 2012
- Messages
- 9,967
- Location
- Northern Ontario, Canada
- Tractor
- 2012 Kioti CK27HST w/cab
Google is or can be your best friend. I found my original link via google. Just google IHC J4 magneto test and go from there.
Ledgemere Farm
Veteran Member
Have a friend hold the coil wire while you crank it ����
Code54
Elite Member
- Joined
- Aug 20, 2005
- Messages
- 4,309
- Location
- Putnam Co. West Virginia
- Tractor
- Kubota MX5100, Kubota BX25D,1957 Farmall Cub Lo-Boy Kubota KX91-3, BCS 853
May want to see:
Farmall H4 magneto diagnosis - YouTube
Farmall H4 magneto diagnosis - YouTube
Soundguy
Old Timer
- Joined
- Mar 11, 2002
- Messages
- 51,575
- Location
- Central florida
- Tractor
- RK 55HC,ym1700, NH7610S, Ford 8N, 2N, NAA, 660, 850 x2, 541, 950, 941D, 951, 2000, 3000, 4000, 4600, 5000, 740, IH 'C' 'H', CUB, John Deere 'B', allis 'G', case VAC
condensers are capacitors. test them with an ohm meter.
short the pigtail to the body to discharge it.
set a meter to Rx1
put leads on the pigtail and body. On an analog meter, the needle will swing from 0 ohms to infinite. On a digital it will go from a low reading, probably auto range a bit, then indicate infinite.
Condensers that read infinite all the time are open, ones that read 0/low and never increase are shorted.
short the pigtail to the body to discharge it.
set a meter to Rx1
put leads on the pigtail and body. On an analog meter, the needle will swing from 0 ohms to infinite. On a digital it will go from a low reading, probably auto range a bit, then indicate infinite.
Condensers that read infinite all the time are open, ones that read 0/low and never increase are shorted.
m1garand762
Gold Member
They cost 5 bucks change it
