sliderbuck
Bronze Member
Anyone know where the diagnostic connector is on the l4060? Mines a 2023 model. Suppose to be one under the hood somewhere.
Diagnostic connector
- Thread starter sliderbuck
- Start date
- Views: 4815
5030
Epic Contributor
- Joined
- Feb 21, 2003
- Messages
- 26,996
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
Probably attached to the ECM itself. It won't do you much good however as it's not OBD compliant and the only way you can access it is with a dealer's hardware diagnostic computer and even the dealers don't own that, Kubota leases it to them.
Do be apprised that fiddling with it or the inside pins can cause issues with the ECM and that isn't a cheap date either.
Do be apprised that fiddling with it or the inside pins can cause issues with the ECM and that isn't a cheap date either.
OP
sliderbuck
Bronze Member
Im just needing it for the can bus wires. After my warranty is up im making some changes.
MessickFarmEqu
Super Member
There is no CAN bus on that tractor.
OP
sliderbuck
Bronze Member
Then why is there a 120ohm resistor at the end of the wiring under the hood?
MessickFarmEqu
Super Member
There are diagnostics, but it's not normal CAN.
mdhughes
Bronze Member
This is what I found in the WSM online:
OP
sliderbuck
Bronze Member
That helps a lot. Thanks. Def know now that it does have a high and low for the CAN. Do you have a pic of #4 and #5? Thatd show exactly where the connector is. Pretty sure i found it though. Its to the right of #2 in the pic.
5030
Epic Contributor
- Joined
- Feb 21, 2003
- Messages
- 26,996
- Location
- SE Michigan in the middle of nowhere
- Tractor
- Kubota M9000 HDCC3 M9000 HDC
Be apprised that when you screw it up, there is no going back.
OP
sliderbuck
Bronze Member
How many times do you have to put a negative comment? If you have nothing to contribute to this post just move on. Not everyone is afraid to figure things out and work on there own things. Ive been rebuilding engines, swapping transmissions, and anything in between since i was old enough to drive. Plus ive got an engineering degree. Im not afraid to figure things out on my own. Guess what if i screw something up i fix it on my own. If youre afraid to do that then thats your issue. Take your negativity elsewhere there Kenny!