Buckgnarly
Platinum Member
Yes, but I had that with mine. I and my friend wound up with a glove of acetylene that ignited....was not fun but no damage done. If in doubt, rebuild it.
Cutting torch questions
- Thread starter psu927
- Start date
- Views: 3841
Yes, but I had that with mine. I and my friend wound up with a glove of acetylene that ignited....was not fun but no damage done. If in doubt, rebuild it.
Shield Arc
Super Member
Stimw
Elite Member
The neutral flame is the important part. Too much O2 is "Oxidizing flame" too actl is "Carborizing flame". You light the torch and dial back on O2, then bring it back up until the blue cone is perfect.
Also learn to use it with the gases fairly low rather than on higher than needed. Gas is expensive!!
Always know what is around you too. Many fires and explosions have been caused by poor torch handling.
Don't cut any vessel (barrel, tank, can) that you are not sure what is/was in it.
Also learn to use it with the gases fairly low rather than on higher than needed. Gas is expensive!!
Always know what is around you too. Many fires and explosions have been caused by poor torch handling.
Don't cut any vessel (barrel, tank, can) that you are not sure what is/was in it.
kcender
Platinum Member
I always turn the acetylene off first.Turning it off last will cause soot to contaminate the tip.
dstig1
Super Member
- Joined
- Apr 7, 2010
- Messages
- 5,628
- Location
- W Wisc
- Tractor
- Kubota L5240 HSTC, JD X738 Mower, (Kubota L3130 HST - sold)
Hard to beat irish Fixit's series on WW on torch use. He's an artist with it...
How to use a cutting torch - WeldingWeb™ - Welding forum for pros and enthusiasts
How to use a cutting torch - WeldingWeb™ - Welding forum for pros and enthusiasts
Here are some similar links:
