Cup Holder

[JohnDeere4300]

The cup holder in the fender of my JD4300 is good for holding nuts and bolts, anything else just bounces out....and gets spilled or lost. Including the $60 clip for my rifle...

That cup holder is a joke.....That's why i bought the other one.

 

[robertm]

yeah...but mine's made by 'Snapper'...(in the USA) wally-world= chinese junk

If you think the Snapper model isn't made in China, imported by ZXQ Distributors, sold to Snapper, then... well... good for you. The one I bought for my son's bike is a Schwinn. Yes, good 'ol American Made Schwinn... parts from China.

 

[cowboy357]

My tractors aint as fancy as most of yours, so I just superglue those little foam coolies on the rear fender They seem to absorb the shock & vibration much more as well . . I Just replace them every couple of months or so . Bob

 

[/pine]

If you think the Snapper model isn't made in China, imported by ZXQ Distributors, sold to Snapper, then... well... good for you

FYI
it says " MADE IN USA"

and by the way about Schwinn...

On September 11, 2001, Schwinn Company, its assets, and the rights to the brand, together with that of the GT Bicycle, was purchased at a bankruptcy auction by Pacific Cycle, a company previously known for mass-market brands owned by Wind Point Partners.[26] In 2004 Pacific Cycle was, in turn, acquired by Dorel Industries. Pacific and Dorel produced a series of low-cost bicycles built in Taiwan and the People's Republic of China, which were badged with the Schwinn nameplate and sold in large retail stores such as Wal-Mart, Target, and Costco.

 

[robertm]

/pine,

Bowing down respectfully. Now, can I get one of those Snapper holders? Do they make one that holds a quart?

 

[Car Doc]

I couldnt help but notice the topic so I thought I would share my home made can holder. I felt it was a necessity and built one for my Yanmar soon after I bought the tractor it also holds gloves or sunglasses when not using the tractor.

 

[JohnDeere4300]

I couldnt help but notice the topic so I thought I would share my home made can holder. I felt it was a necessity and built one for my Yanmar soon after I bought the tractor it also holds gloves or sunglasses when not using the tractor.

Welcome to TBN!

Nice job!

What did you make that out of ?

After looking again....Is that a spring from a vehicle?

 

[Car Doc]

Welcome to TBN!

Nice job!

What did you make that out of ?

After looking again....Is that a spring from a vehicle?

Thanks Bill!

Yes that one is a old coil spring off a dune buggy shock just happened to fit my brand of beer perfectly also bottled water. The new design is cold rolled 3/8 round turned on a lathe with a jig to make the coiled shape which will be better less prone to crack the welds.

Steve

 

[Charlesaf3]

Thanks Bill!

Yes that one is a old coil spring off a dune buggy shock just happened to fit my brand of beer perfectly also bottled water. The new design is cold rolled 3/8 round turned on a lathe with a jig to make the coiled shape which will be better less prone to crack the welds.

Steve

beyond my skills, but thanks for posting it! nice!