Covington Cutter

[Roadglide3]

I purchased A 5' Covington Cutter. The problem is that There is no slip clutch or shear bolt arrangement on the drive shaft. Is this safe? The cutter has a 1 3/8 spline shaft as does the tractor.

 

[geneP]

I have an old Covington cutter that I junked a few years ago. It also had no gearbox protection. I used it for about 25 years and cut many 2"-3" sapplings and never hurt the cutter or the tractor(s). I'm not saying this is the wise way to go, but just my experience.

 

[sweettractors]

If you need one? We have the new clutch that would go on the 1 3/8 inch diameter-6 spline shaft--Ken Sweet
Email: sweet@scrtc.com

 

[HayDR]

Check out CCM- "PTO Shaft Headquaters"

 

[slug431]

I own a Covington cutter. Was built I think in the 50's. I need to replace the bottom seal, but I can not find any numbers on the seal. Please help.

Bruce