can it be welded, or do i buy new muffler.?

   / can it be welded, or do i buy new muffler.? #1  

jwjsr

Member
Joined
Mar 7, 2014
Messages
35
Location
ALA
Tractor
ford 4000
All I have is a bernzomatic and propane or Map gas cylinders??
 

Attachments

  • IMG_1445.jpg
    IMG_1445.jpg
    405.9 KB · Views: 276
  • IMG_1446.jpg
    IMG_1446.jpg
    365.4 KB · Views: 291
   / can it be welded, or do i buy new muffler.? #2  
From the looks of the rust in the second pic I doubt you could get the metal clean enough to weld it. Think its time for a new one.
 
   / can it be welded, or do i buy new muffler.?
  • Thread Starter
#3  
From the looks of the rust in the second pic I doubt you could get the metal clean enough to weld it. Think its time for a new one.
You know a good source for kohler Command v twin 27 hp mufflers?
 
   / can it be welded, or do i buy new muffler.? #4  
Have it brazed.
 
   / can it be welded, or do i buy new muffler.?
  • Thread Starter
#5  
From the looks of the rust in the second pic I doubt you could get the metal clean enough to weld it. Think its time for a new one.

i had someone put i new engine in about 7 years ago and they didn't put the heat thingy back on and resulted in the heat frying the choke and throttle cables. Now when the muffler busted it burned the wiring harness, but not enough to short anything,
 
   / can it be welded, or do i buy new muffler.? #7  
Make a tinplate cap that fits over the hole and pop rivet it into place. Seal it with lots black silicone and paint it black. Ive repaired a couple of mufflers this way. Its easy and if you do it neatly they look as good as new. (I do have a welder, but trying to weld thin, rusty metal like this is too hard.)

Probably what I would do in this case is use the existing cap and pop rivet some tabs to it that can then be pop rivetted to the side of the muffler.
 
   / can it be welded, or do i buy new muffler.? #9  
i don't see good weldable or brazeable material there. I think i'd go the pop rivit route. use soem of that strapping tape. or cut strips from roof tin.. etc.. drill locations. rivit and forget about it..
 
   / can it be welded, or do i buy new muffler.? #10  
It might get too hot for brazing and that's only if you got ALL the rust off first.
 

Tractor & Equipment Auctions

Case SV 340 Skid Steer Loader (A52349)
Case SV 340 Skid...
2017 Ford F-250 Knapheide Enclosed Service Truck (A50323)
2017 Ford F-250...
2006 Audi A6 AWD Sedan (A50324)
2006 Audi A6 AWD...
2018 Toro Groundsmaster 7210 72in Zero Turn Commercial Mower (A50322)
2018 Toro...
2014 INTERNATIONAL 7400 SBA 42 LUBE TRUCK (A51406)
2014 INTERNATIONAL...
Pull-Behind Smooth Drum Ballast Roller (A51691)
Pull-Behind Smooth...
 
Top