Bobcat S185 17-07 error code

[KellygC]

Skidsteer stopped running while idling. Wouldn't restart, "input" displayed in hour meter. Later code of 17-07 came up. Cleaned all grounds, checked main wire harness connections for corrosion(none found). All fuses and relay check out ok. HELP!

 

[JJZ 109]

The code is hydraulic lock solenoid open circuit in case you haven't already looked that up somewhere. Hopefully Dennis (SSdoxie) will see your post and give a reply. He's the Bobcat guy on this forum.

 

[SSdoxie]

Code means lost communication between main controller and left panel or right Deluxe (keyless panel) if equipped. Communication wires are numbered4 digits and all start with 91. Go to back of each panel and main controller (located in left front fender area). check and wiggle plug connections to see if disappears. If it does remove the connections, clean and apply light coat of dialectic grease.
Also check these wires for continuity of short to ground and/or power. There should be no connection to ground or power with power OFF.