B2710 Hydraulic Case/Tank Return

bnold · Nov 21, 2020

Have a B2710 I’d like to add a set of rear remotes to.

Have the valve with open center/Power beyond kit as well as the Kubota hydraulic piece to mount on the side of the transmission case. (Plate is removed and this piece is bolted in its place for an hydraulic in/out). Question is, I believe this plate is before the pressure relief valve in the system, so I need to use the T port on the valve to dump back to the tank.

Not sure where to do this other than the fill port on the transmission case.

Help appreciated!

Dave M7040 · Nov 22, 2020

bnold said:
Have a B2710 I’d like to add a set of rear remotes to.

Have the valve with open center/Power beyond kit as well as the Kubota hydraulic piece to mount on the side of the transmission case. (Plate is removed and this piece is bolted in its place for an hydraulic in/out). Question is, I believe this plate is before the pressure relief valve in the system, so I need to use the T port on the valve to dump back to the tank.

Not sure where to do this other than the fill port on the transmission case.

Help appreciated!

If you have a loader, Tee into the Tank line of the loader valve.

Dave M7040

bnold · Nov 22, 2020

No loader on this one.

Henro · Nov 22, 2020

Starting at post #27 in the following thread There are some pictures of where I put the return to tank on my B2910, which is identical to your B2710. This is (I think)where the my loader returned to tank. Perhaps you can use this point?

https://www.tractorbynet.com/forums...r-ending-t-t-path.html?highlight=T&T+path