Andrew Camarata

   / Andrew Camarata #331  
Cued to start at the fun part. Watch for the next minute where things go south. He's lucky.


It started from the start. What part is the fun part?
 
   / Andrew Camarata #333  

this is worth watching. First he fixes the winch on his dozer and then uses it to pull an old Subaru Outback literally in half, at the end.
actually quite entertaining.
Nice 5k video, my new monitor supports it and his stuff when focused right on is really good to look at. That drone he uses must be high end for 5k; just glad
he uses it. His stuff defaults to a lower setting but if you have a good monitor, you can go into the menu and pick the highest available. The difference between 1080 and 4k is huge, not sure what 5k does. Probably requires 5G to stream it.

it was nice to see him working on big old equipment again, and taking his time to do it right.
 
   / Andrew Camarata #334  
So that winch was fully hydraulic? he said some stuff in a previous video that confused me or I misheard him.
 
   / Andrew Camarata #335  
So that winch was fully hydraulic? he said some stuff in a previous video that confused me or I misheard him.
I believe he said the winch was PTO driven and the brake and whatever the other control was, is hydraulic.
 
   / Andrew Camarata #336  
The pto drives the hydraulic pump. The pump powers the winch. The pto has a forward, neutral and reverse to change the direction on the cable and allows a neutral position.
 
   / Andrew Camarata #337  
The pto drives the hydraulic pump. The pump powers the winch. The pto has a forward, neutral and reverse to change the direction on the cable and allows a neutral position.

The hysters I believe the gearing is on the hydro side.
 
   / Andrew Camarata #338  
The video is worth watching in its entirety if you're a gearhead.
 
   / Andrew Camarata #339  
Yeah I was curious because I thought he said mechanical with hydraulic controls or something.
 
   / Andrew Camarata #340  
The hysters I believe the gearing is on the hydro side.
Could be, there might be just an on or off on the pto, but I saw no controls on the hydraulic side. I
watched the whole video. Never worked on a Hyster or a Cat, my experience has been with Komatsu,Dresser,Fiat- Allis and a couple others. Have a good one!
 
Last edited:

Tractor & Equipment Auctions

2013 FREIGHTLINER EXT CAB SERVICE TRUCK (A51406)
2013 FREIGHTLINER...
2017 Buick Regal Sedan (A50324)
2017 Buick Regal...
2011 IC Corporation PB105 School Bus (A49461)
2011 IC...
2021 Dosko 337S-13HC Walk-Behind Stump Grinder (A49461)
2021 Dosko...
2001 KENWORTH T800 TRI AXLE TANKER TRUCK (A51222)
2001 KENWORTH T800...
2003 Pierce Fire Truck (A50323)
2003 Pierce Fire...
 
Top