Additional Tool Storage

   / Additional Tool Storage #1  

Baby Grand

Elite Member
Joined
Nov 12, 2007
Messages
4,649
Location
Windsor, CT.
Tractor
Kubotas: L3240GST B2320HST B5100D & G5200H
Didn't want to hijack the other thread ...
This is my headache tractor rack - it allows the ROPs to fold and I discovered an unintended benefit: additional tool storage!
Very cheap, some scrap hurrcane fence, a pack of zip ties and a few bungies:

P9050012.jpg

P9050013.jpg

P6160020.JPG

-Jim
 
Last edited:
   / Additional Tool Storage #2  
I like the idea of the "backstop". My Bush Hog has a habit of occasionally zinging something out the front past the rubber guard. Had it do so,object hit a tree I was driving past and sailed it over my head. Don't know what it was, but go into the crouch position since then when near a tree.:eek:
 
   / Additional Tool Storage #5  
Thoughtful, clean, practical.....To bad it won't work with my backhoe.
 
   / Additional Tool Storage #6  
Can you explain the sub-soiler/potato plow positioning and what you use it for? I am very curious about it.
 
   / Additional Tool Storage
  • Thread Starter
#7  
Thoughtful, clean, practical.....To bad it won't work with my backhoe.

heh-heh. That would make spinning around in the seat a bit difficult, wouldn't it?
 
   / Additional Tool Storage
  • Thread Starter
#8  
Can you explain the sub-soiler/potato plow positioning and what you use it for? I am very curious about it.

That, my friend, is how I came to think of the fencing as a tool holder and not just a headache rack.

To pin the subsoiler out of the way for transport I take out the top link pin, pivot the SS up horizontal, lay the top link on top of the spar, then secure the whole mess with a bungie.

When I got to the field, I reversed the steps, but now I had a bungie & nowhere to put it. No more room in the toolbox, so I just hooked it to the fence. I left it there for whenever I needed to transport the SS again.

A few days later, I had the same issue with the loppers - nowhere remotely convenient to put them. So I slipped the jaws into a gap in the fence and repositioned the bungie so I could slip the handles under it. Now I'm working on getting a good, secure mount for my chainsaw using a similar attachment.
 

Tractor & Equipment Auctions

2015 CAT 573c Fellerbuncher Cutter (A48836)
2015 CAT 573c...
2015 JEEP PATRIOT (A51406)
2015 JEEP PATRIOT...
2004 Chevrolet C5500 Shuttle Bus (A50323)
2004 Chevrolet...
WHITE CI-7 DRAW WORKS POWERED BY TWIN DETROIT 12.7S (A50854)
WHITE CI-7 DRAW...
2010 John Deere Gator UTV (A49461)
2010 John Deere...
Unused Delta Crash Attenuators (A49461)
Unused Delta Crash...
 
Top