Adding hydraulic for backhoe Massey 1755

[Range rider]

I was going to take off the power that control grapple through a w r long switch. So it would go PB to w r long switch and take the P from switch back to backhoe PB input and then from backhoe P back to P input on tractor will I have any issues thanks

 

[K5lwq]

I am not sure I understand fully your plan. With the WR kit you would simply plumb the solenoid valve using the power in line for the backhoe then go from the solenoid valve back to the power in of the backhoe. No other changes have to be made. Good luck.

 

[ericm979]

Put the backhoe valves after the loader and grapple valve. Many BH valve stacks can not handle full system pressure. If you have the grapple after the BH and use the grapple you could damage the BH valves.

 

[Range rider]

The pb runs to the wr long valve for grapple out the wr long valve to the backhoe then back to t when backhoe is hooked on when. When backhoe is unhooked jumper is in place the backhoe input is connected to a line back to p easy to say hard to explain

 

[K5lwq]

Sounds correct to me.