I have a 35 ferguson that the hydraulics quit working so I replaced the pump. Now when I start the tractor the lift arms go all the way up no matter the postion of the lift lever. The arms will only come down when the tractor is turned off then they just drop quickly. Any idea what's happening ?
35 Ferguson problem
- Thread starter Big H
- Start date
- Views: 744
Leejohn
Elite Member
I'll see if I can get some others to tune in. This is a real shot in the dark, but here goes. Broken spool or leaking past real bad and the base in of the cyl over riding the rod end. Now is all you done was to R & R the pump and nothing else?
pjbci
Platinum Member
- Joined
- Feb 10, 2012
- Messages
- 780
- Location
- Summit. Ms
- Tractor
- JD 4840, Deere 5075e, 450j, Cat D4k2, Kobelco 160, Volvo EC140el, deere 310, komatsu D31px22, IH 1486, MF 135, MHF TO35
Is the draft control lever (lever closest to fender) all the way in either direction?
One of the people I took it to did hone out the lift cylinder and replace the piston since a ring was stuck. Iv'e tried the draft control in all postions and it doesn't make any difference. I pulled the inspection cover off and the lift lever doesn't move anything inside, like it's not working at all. Thanks for the help so far.
Leejohn
Elite Member
"I pulled the inspection cover off and the lift lever doesn't move anything inside, like it's not working at all"
What cover??
What cover??
Leejohn
Elite Member
How I see what covers I think that girl has you covered on the whole system!!!!
Leejohn
Elite Member
I asked what covers and see now what was being talked about. I way off base from the post I put on earlier.
