2016 TYM 1003 Transmission

[john FunnellTMY]

Hi, I have a 2016 TYM 1003. Works well until the I work it mowing or bailing and if I take the shuttle from the forward position to neutral or revers, it then wont move forward until I let it cool down for around 5 minutes. It will go backwards but not forwards. Any one have any suggestions as it has only done 1984 hours total.

 

[K5lwq]

To let it cool do you just pull it down to idle or do you shut it off?

Is it low on hydraulic fluid?

Does it have a hydraulic oil cooler? If so, has it been cleaned?

 

[john FunnellTMY]

I just let it idle for around 5 minutes and it is then OK to move forward again. The oil level is OK. It does have a separate oil cooler and I have cleaned the screen (which had very little grass stuck to it) and it has made no change.

 

[K5lwq]

I would look closely at the cooler fins and maybe do a good cleaning. It sounds like the fluid is getting too hot. I can not think of any other reason for it to work once it has cooled down some. Hopefully someone that knows more about the system will give better advice.