1300 hyd seal

[larryreyer]

Ford 1300, I need the seal for the piston in lift cylinder. where might I get one from ??? thanks

 

[wdchyd]

Pics?
Dimensions?
Location?

 

[larryreyer]

[?.....seal maybe?,..1200 X 900. was at bottom of these pictures...?.....on messicks (website won't let me post the complete address) at ?sectionId=9393&diagramId=57923_322660...????part no. 19

 

[wdchyd]

Take the seal off the piston, get a few dimensions of the groove and the bore with calipers or micrometer. I may have that seal, pm me. Looks common.

 

[larryreyer]

 

[wdchyd]

Common ID and OD, there痴 a difference on the seal height though (double check that groove width of .360?. My catalogs show 4 different choices by groove width...... .260? .275? .433? .519?

Best bet is to check through your OEM tractor supplier, if no luck I can fix you up with something that works.

 

[larryreyer]

I found one, almost right next door. connection was through the local tractor club. Thanks, man, I'll keep your name and number, I always need tractor parts. ( never was too good at reading those mics )

 

[larryreyer]

I found one, almost right next door. connection was through the local tractor club. Thanks, man, I'll keep your name and number, I always need tractor parts. ( never was too good at reading those mics )

OK, so`, the lip on the seal goes on the pressure side for lifting, how do I hold the pushrod inside up to get the piston to it ?H=CONFIG]662000[/ATTACH]

 

[larryreyer]

I got it

 

[larryreyer]

new seal works great, but after it warms up, all lifting quits, works for a second, pressure hits 1300, then nothing. there is noise comming from the lower part of trans, like a relief. also is alot of air bubbles in the returning oil..............thanks