12 volt power source

[n219ct]

Hi,

I have a 2005 4320 and I am adding a Fasse diverter valve to my third hyrdraulics. I need a 12 Volt power source back there to operate the switch.

I noticed a wire stubbed out right behind the seat and it has a small clip-on adapter attached to the end. The adapter seems to loop the the wires back on themselves. Does anyone know if this is a 12 volt power source for auxiliary electronics and does JD sell a part to clip right in to it rather than splicing and taping it?

Thanks in advance,

John
__________________

 

[kennyd]

I think that may be for the optional work lights, but you will have to test it with a VOM or testlight to be sure.

 

[wolc123]

That is for the worklight and it will only be "live" when the light switch is in the correct position (symbol with downward facing beams). I fabricated a bracket to mount a single 12 volt light I had laying around to the rollbar, centered behind the seat, which I use for snowplowing at night with a rear blade. This works pretty good but I would like it if there was a light switch position that would allow the flashers and the worklight to be operated at the same time. If I get time this winter I will run power from another source and install a seperate switch to make that happen.

 

[Mayor]

Loogie did a really cool set up off the side fender but I can not find it. Maybe it was the other site. Any way take a look, the switch was run without cutting into the OEM wires.

http://www.tractorbynet.com/forums/...5494-new-green-2305-a-4.html?highlight=loogie