Recent content by SSdoxie

The fuel is drawn up from bottom of tank through a pickup tube coming out the top of the tank. That tube maybe damaged. First take the hose of the inlet side of the primer bulb, put thumb over end of the bulb and squeeze it checking or good bulb function. If bulb tests OK, then follow the...

Cannot say why you are not seeing a fault code but when the valve light is flashing means the main controller is detecting a fault. The number of flashings between a slight pause. A steady flash (1 blink then pause) indicates open circuit in the power output wire. Keep in mind there are 2...

When warning light comes on there should be code. DO NOT turn key off or push stop button before pushing the "hold for code" light button. There is only one brake line output from valve then tees off to front and rear brake. One axle cannot lock up hydraulically without both locking up.

Here is a clearer pic of the Bobcat, grill and screen sure look the same to me. If the Kioti screen is not exactly the same it should be close enough to make it fit.

Oliver Super 44 offset Nore: front grill is different but that could due to production year.

The reverse end of your pedal is bent downward where red circle indicates. Picture shows it being almost horizontal, it should have an upward arc. No idea how or why it bent but it is.

The fuel solenoid has 2 power circuits feeding it. One is a momentary high amperage input to pull the solenoid ON then shuts off, the second is a lower amp input that holds the magnet in place. Hearing 2 clicks when you turn the key on indicates to me that the fuel solenoid is not working in...

The attached is parts illustration for that 9TL loader. Note: item #12 bushing requires qty 8, means these are used on the front 4 bolts of each bracket. Looks like they used a bushing spacer rather than offset the plate. If these bushings are not in the kit probably best to order from Bobcat...

Here is the schematic for it. Let us know what you find.

This may be just the style of steering system used. In their previous models CK & DK series Kioti used 2 different systems. The CK 20-35 had "Load Reaction Steering". The when steering wheel was not being turned, the oil in steering cylinders was blocked at the steering orbital motor. This...

The bucket that came with the loader is 68" and grapple is 60". When using it for loose brush it will grab enough with branches hanging over the sides to make it interesting weeing where your going heading to the burn pile. Mine is a modified skidloader bucket with single grapple fork. If I...

My mistake. That one is different than some other models. That bolt holding pin in form the bottom comes out then pin comes out the bottom. Here is the R&R steps from service manual.

There is steel plunger under the magnetic solenoid. Plunger has a steel block on it that drops down into notches in the brake discs when power to solenoid is turned off. Below is part illustration for reference. It is possible brakes were not releasing properly and rather than fix the...

No disassembly of valve required. Just remove the plug cap currently in valve and install. If he has the hoses connected to correct coupler on the boom, the this plug goes in the top side of the valve as it sets in the machine. It is shown in the installation instructions for the clamp...

Jabonee is correct that there is not a port relief in that auxiliary valve section, but there a simple port relief installation for this. Below is quick photo snip taken from the Installation Instructions for a Bobcat Thumb. For this serial number order Port Relief part number 6680065 and...