Recent content by av8tr72

I have a 105A. A couple of times I have started it to warm it up. I noticed the yellow caution light will come on. Yellow light with the exclamation mark. I also noticed that the engine will rev up on its own. It will run about 500 rpm ( I believe) at idle but it will go up 1000 rpm on its own...

Yeah. Good point about the right door glass. I guess this could solve half of the problem.

Yeah. It’s a cover to keep from breaking glass I guess. I watched the video and looks like there is a strap that goes around and then I assume some suction cups? Not sure if that would stay on in a rough field.

I was surfing the web and saw this, has anyone ever used this? Looks like it could potentially be good but not sure about the mounting. If someone has used it I’m Interested in the good or bad. https://usfarminnovations.com/tractor-guard/

There was an adjustment somewhere. They came and picked it up and made the adjustment.

I am by no means an expert on any of this so it’s worth what you pay for it. I had a 60hp Kubota tractor and had no issues. Looked at getting a bigger one and was considering the M-111. Talked to the dealer and they recommend the Case when you step up to over 100HP tractor. Basically his...

Well I took my time but finally got it done. Some of the bolts just broke right off. Most I had to just cut off. I found a wrench that would fit those that where close together but could only turn about 1/8 of a turn [emoji849] so that was slow going. I’m just glad it’s over.

Roger that on the swear words. I think I owe Mr Massey and Mr Furgeson an apology after the last round.

Doubt any of them are. Just trying to get the new ones on. Have some from bolts agri supply. My open end wrench didn’t quite fit. Guess I’ll have to go search for a thinner wrench.

Surprisingly I am able to loosen a lot of the bolts. Those might be quite hard due to their location. But once I get them loose they just spin. So I have to cut them.

I guess the only option is to cut more and order more bolts. Was hoping to avoid that.

The other one is holding the land side.. or slide? that the right term? Didn’t want to cut that one off if I didn’t have to. I guess I’ll have to run to Home Depot or lowes. Can’t quite get on in there. See if they have a wrench narrow enough to fit in there. They are real close to touching

So I have this old (new to me) plow. Wanting to replace shins on it. There are 2 bolts and the lower one is in the picture below. It’s the one in back of course. About the only way to get them off will be to cut them, not a huge problem…. But.. how would y’all get it back on. It’s going to be...

So I have this old (new to me) plow. Wanting to replace shins on it. There are 2 bolts and the lower one is in the picture below. It’s the one in back of course. About the only way to get them off will be to cut them, not a huge problem…. But.. how would y’all get it back on. It’s going to be...

I’m trying to figure out how to raise and lower my 3 point arms. I don’t have the controls on the back of the tractor. With the quick raise forward I can only fully raise the 3 point to lower it. If it’s only half way raised it will not lower the bars I have to go full up. I’m guessing with the...