Here is a PDF for how I did it. I hope it helps you.

Quite simple to replace the seals.

Good day, I would like to add an additional circuit to the rear of this machine. I would like to be able to run things like a grapple, post hole auger or even wood splitter off the end of the...

We have an 83' JD 410 TLB, Used for just a little bit and discovered the hydraulic fluid was real low, filled up. Tractor works just fine in forward/reverse in LOW range but will not move very...

I need help I have a 410 Backhoe when I was digging I lost all Hydraulics and will not move but motor still runs. What do you think?

Need a 1,1/4 inch female 14spline sleeve Part#T58193. This sleeve comes off the front of the motor and runs the hydraulic pump

Operated the tractor yesterday, today it won't crank over. ran a jumper wire from the starter solenoid and it cranks find so the battery and starter are good. What should I look for next?

after sitting for a week and a little rain exposed, my john deere 410 c would barely turn over. after some trouble shooting including a smoking starter, I ordered a new starter installed and it...

i have a john deere 410c tractor with backhoe. after sitting a couple weeks and a little rain, it wouldn't turn over. the starter smoked so i ordered a replacement and 3 days later with new...

Does anyone know how to remove the nut to draw out the piston? It just spins but won't back out. Any tricks would be appreciated...

Hello all! I just recently purchased a JD 410 with a fair share of issues. I'm having issues with the drive system and hydraulics. It will only drive with the left stick forward (is this high or...

Hello, Members. I have JD 410 backhoe has some issue that loader boom respond very slowly after 20-30 minute operating the tractor. I am sure It was not hydraulic pump problem because backhoe boom...

Hello, Members. I have JD 410 backhoe has some issue that loader boom respond very slowly after 20-30 minute operating the tractor. I am sure It was not hydraulic pump problem because backhoe boom...

I have a problem with my john deere 410 backhoe. It will move reverse but not forward. I have checked the linkage and the pin and it was all ok. I checked the low pressure PSI for the forward and...

Hey everyone I got a new project which is a straight JD 410 backhoe. Completely rebuild the entire motor 4cyl diesel. But the mot back in and now she doesn't want to move. She will go into all...

Hello I'm new to this forum and my name is Jack. I just picked up a John Deere 410 Backhoe and it worked ok for a couple days and now it will barely move forward but it moves ok in reverse. I...

I have a 1974 JD 410 that is in great cosmetic conditions. Looks almost new but the pump is very weak and needs to be rebuilt or replaced plus there is a one leak in the backhoe arm. Tires need...

Gentlemen, thanks for the invite to the site. I am in the process of rewiring my machine, any help with parts or info will be greatly appreciated.

i bough this john Deere 410 tlb late 70s diesel about 2 weeks ago and am having an issue when i started Thursday it ran fine for about 30 minutes than stall out let it sit for about 5 minutes and...

hi i just purchased a john Deere 410 tlb with no backhoe, year is unknown but should be about the early 80s and i am having issues starting it it has the 4 cylinder diesel and and when i crank it...

I have recently purchased my first backhoe for use around my home. It is a 1979 John Deere 410 in what I think is fair shape for the age. Typical problems such as zerks that won't take grease...

How do you remove the spider gears from a model 410 john deere backhoe

I'm looking at a buying 1983 JD 410, however I'm concerned there may be a problem with the reverser or main clutch. When I drive the tractor, if I try to start out in high range 1st gear (5th...

Hello. I am new to the forum, and the thing that caused me to join is that I have a simple question for those of you familiar with the JD 410. I have a backhoe that was my uncle's. Due to...

Have an old 1970s john deere 410. My dad was running it yesterday and he was pushing some trees around we had cut down previously. He started to push forward and the hoe bucket was dragging, so...

I started her up, drove over to my fuel tank, started filling the tank, the engine seemed to bog down and then smoothed out and ran back a idle just fine. I finished the fueling, got back in the...

My 410 backhoe has a leak which seems to be coming from the plug located on the bottom of the pump. I have the Tech Manual and I took the plug out, replaced the O-rings but it still leaks. The...

Have a 410 in my shop, was brought to me last week owner said clutch was slipping, I did question him as to if he was sure it was the clutch and not the reverser that might be the problem. The man...

A year ago I was using my jd4100 to mow and all of a sudden the front bucket on the FFEL was scraping the ground. I realized the dump function on my FEL was activiting even though I wasn't...

I am having a problem with the high/low/park shifter lever. The backhoe wants to move when the shifter is in the neutral position. When you shift it into low the backhoe just bogs down. I also...

Just wanted to show a project that I am currently working on. I need a new (used) loader bucket for my 410. The thing has been very abused over the years and is just too far beyond repair to save...

I have a late 70's early 80's JD410 loader/backhoe. I used it perfectly fine for 4 hours clearing snow, backed it into my garage when finished, went out 3 days later to move more snow and the...

Topping up the trans/hyd fluid in my 1978 JD 410 today when I realized that I was adding the hydraulic fluid for my Case farm tractor. I probably put less than two litres in before I realized what...

I'm helping a friend out trying to find a swing arm frame for his John Deere 410 backhoe (1980). If anyone has any ideas of where I might find one for sale...without cracks :laughing: I sure would...

I am Looking at purchasing a JD410 it has two gear levers what is there functions The left one when moved to the left and forward does nothing. Thanks Dan

I have a late seventies jd 410 backhoe that has fresh oil and filters in it. The dry clutch is good. When I try to drive it up hill even in lo range 4th it slips I had to shift to first gear to...

I have a late 70s 410 back hoe. Just got it out for the first time this spring the first day it worked great. Went to move it today and it will go in reverse fine but take a while to go forward...

Okay guys, me and my father-in-law took a chance on an old JD 410 backhoe that supposedly had a rebuilt engine 140 hrs ago. Was hard to crank, but it ran good when cranked, so we took it. Had a...

My bucket won't stop falling forward. The bucket slowly drops forward until it is completely in the dump position. I hear a small hydraulic sound when I put my ear to the cylinder. I suspect...

I have a John Deere 410 backhoe. It has a standard bucket on the front and of course the backhoe on the back. I want to make it more 'all around' useful and am considering adding a thumb to the...

My neighbour has a John Deere backhoe that the decals say is a model 410. The tag on the frame above the right front axle has serial number: 410D 37598T. We would like to know the production...

Hello all. First post and I'm in a bit of a jam. First I need to correct something in the title of this post. I ran it out of "fuel" - it's a diesel not gas motor. I ran my JD 410 Backhoe dry on...

I have been having a problem with my 410 backhoe quitting after it has been running for a while. It acts like it is running out of fuel. Let it set for a few minutes and it will start again and...

Hello, I have JD 410 Backhoe and one day while digging some roots I put a crack in the bucket up the side of one of the fingers 5-6 inches long. I also have been keeping a close eye on a hairline...

I am looking at purchasing a 1980 JD 410. Are there attachments available for this model? Stuff such as a concrete breaker, or an auger? Where could I find what is available and/or compatible...

Hi, I', new here and new to tractors. I am looking at purchasing a 1980 JD 410. It has 2,000 hours on it, which I understand to be pretty low. It runs fine, and is ready to work. What is a...

my fathers old 410 needs parts , specificly a drive roller and gear but may be interested in the whole bailer if not to far away

This works, just wondering if anybody'd care to speculate what I might be able to get for it.

I own a 1974 John Deere 410 commercial loader backhoe unit and had a question for all of you who own an older one like me. Mine seems very unstable on uneven ground even when dry, and was...

Hi Everyone, 1 yr lurker, 1st time poster. Anyways... I was trying to push over a tree this weekend with my John Deere 410D Turbo Backhoe, and the backhoe arm was pushing me off the ground as...

What is an acceptable price or price range of a Deere 410 loader attachment with brackets in good shape? What did they cost new?

Looking for someone with a JD 410 loader. Several questions: I have a box blade attached. Do I need a ballast box? Is the 49 inch bucket OK? Is it difficult to attach and detach the loader on the...

Never to early to start thinking about winter! So I thought I would take my old JD 425 front blade and an extra front mount I had laying around and setup a front blade for the loader. Had a...