ym226d hydraulic issues?

[kenmac]

When my ym2000 had a bad valve on the 3pt it was letting fluid bypass it and constantly was running and overheating the fluid and when Hot i was like Kenmac and would loose lifting speed and ability.

If I knew for sure that replacing the valve on my 3 pt would correct my loader problem ,I would replace it

3 pt works fine when fluid gets hot. just not the loader

 

[clemsonfor]

Could the loader valve be bad? its a cheasy one anyway, i assume factory? its the type that has the lynch pin holding the stick to the control..it dont have a rubber boot etc. I been wanting to replace it anyway, what is a affordable loader valve people use on these yanmars?

The valve is the first place i would look, esp if the main line hooks to it prior to going to the 3pt.

 

[clemsonfor]

DeepNdirt, my YM2210 had the Buhler 195, recently sold..now that loader was very responsive, immediate actually..kinda miss it but I needed the 4WD of the YM226 which has a yanmar brand yfl800 loader..I will take a pic of the loader valve, its a crappy design imo.

I think the yanmar loader is a bushhog loader rebranded. I think California has covered this and even posted some proof pics??