lynn_florida
New member
- Joined
- Mar 4, 2006
- Messages
- 11
Can anyone give me the tightening sequence and torque settings for head bolts on this model of yanmar its the 3 cylinder diesel thanks /forums/images/graemlins/confused.gif
yanmar ym2610
- Thread starter lynn_florida
- Start date
- Views: 1401
-
- Tags
- yanmar ym2610
- Status
buppy69
Platinum Member
Start in the center work outward in a clockwise direction. For specs, post this at the Yanmar site.
Eugene
Eugene
RoyJackson
Rest in Peace
- Joined
- Nov 17, 2001
- Messages
- 24,646
- Location
- Bethel, Vermont
- Tractor
- John Deere 4052R Cab,, Deere 855D UTV, Z920A Zero Turn Mower and assorted implements
"Start in the center work outward in a clockwise direction"
I'd suggest you strart at the center, then work a criss-cross pattern...that is, torque one bolt near the center, then torque the bolt across the head. Work out from the center in both directions. I hope I made that clear enough.
This pulls the head down evenly.
Also, suggest you do a progressive torque. That means the first torque should be ~ 30%-40% of the finish torque value, the 60%-70%, then the final torque
I'd suggest you strart at the center, then work a criss-cross pattern...that is, torque one bolt near the center, then torque the bolt across the head. Work out from the center in both directions. I hope I made that clear enough.
This pulls the head down evenly.
Also, suggest you do a progressive torque. That means the first torque should be ~ 30%-40% of the finish torque value, the 60%-70%, then the final torque
MikePA
Super Moderator
Duplicate thread.
Refer to this thread.
Forum Rule 2. Do not cross-post your message to multiple forums.
Thread closed.
Refer to this thread.
Forum Rule 2. Do not cross-post your message to multiple forums.
Thread closed.
- Status
